This is a design circuit transient voltage that is built by LM340. This is a simplest form design. The figure of the circuit is shown in below.
If transients exceed the maximum rated input voltage of the device, or reach more than 0.8V below ground and have sufficient energy, they will damage the regulator. The solution is to use a large input capacitor, a series input breakdown diode, a choke, a transient suppressor or a combination of these. [Circuit source: National Semiconductor Notes].
If transients exceed the maximum rated input voltage of the device, or reach more than 0.8V below ground and have sufficient energy, they will damage the regulator. The solution is to use a large input capacitor, a series input breakdown diode, a choke, a transient suppressor or a combination of these. [Circuit source: National Semiconductor Notes].
0 comments:
Post a Comment