Pages

WELCOME TO "SIMPLE PROJECT CIRCUIT"

Simple Remote Sensor System Pre-Amp

|

This is a design circuit for remote sensor might cause a trouble if it’s a passive type, has very low power output, and should be connected with relatively long cables. By supplying a current or voltage source through its connection wire, it’s possible to make long enough wiring without suffering much noise/interference. The following schematic diagram show a circuit consist of LM10 to make a remote vibration sensor connection works fine. We don’t need a separate wires for signal and power supply, we send them on the same cable pair. This is the figure of the circuit;
 

[Circuit diagram source: National Semiconductor Application Notes]

0 comments:

Post a Comment

Recent Videos

 

©2009 Simple Project Circuit | Template Blue by TNB